|Servo Variable Speed Power Feeds for Milling Machines
Click Here for more information or to order
SERVO power feeds weigh approximately 15 lbs. and do not cause table deflection problems. Standard features include electric limit switches, manual reset overload breaker and an 8 foot line cord. SERVO power feeds come as complete kits, with installation instructions and mounting hardware. Power at 110 Volt, 50/60 cycle, 2.5 amp.
- Improve finish.
- Simple controls.
- Maximum cutting rates.
- Eliminate awkward gear changing.
- No loss of dial and handcrank.
- Electric limit switches.
- Safety clutch.TABLE FEED
TYPE 140 - Provides a continuously variable 3/4 to 25 in./min. feed rate, 35 in./min. rapid traverse and 140 lbs. of torque. Helical gearing, an internal clutch and improved universal motor make this the new standard for Class 1 mills up to 2-1/2 HP.
TYPE 150 - Utilizing a full-wave SCR control and compound DCX motor, is the ideal choice for larger (1 to 3 HP) mills and where superior speed regulation is required. It offers 150 lbs. of torque and an expanded 3/4 to 35 in./min. speed range.
CROSS FEED - For the cross axis of most milling machines is also available in both Type 140 and Type 150 versions. As with table feeds, they come with a pilot light, on/off switch, protective circuit breaker and travel stop/limit switch assemblies.
KNEE FEED - For the knee axis eliminates tedious hand cranking and comes in two versions. The variable speed model has a speed range of 3/8 to 15 in./min. and provides 140 lb./in. of torque. Limit switches and stops are standard.